Belden Grass Valley KALEIDO-X16, Инструкция по установке и обслуживанию

Страница: 91 / 152

91
Kaleido-X16
Hardware Description & Installation Manual
Configuring an Audio Bridge Terminal
The optional Audio Bridge Terminal (ABT) is an external audio multiplexer/serializer for the
Kaleido-X16. The Kaleido-X16 supports audio channel inputs from the ABT-64 or ABT-128
series of Audio Bridge Terminal panels through the ABT/MADI inputs. The ABT-64 supports
64 channels and the ABT-128 supports 128 channels.
The ABT provides connector space for audio signal inputs, and multiplexes all the audio
signals into combined serial feeds on coaxial cables that connect to the multiviewer.
To configure the IP address and other network settings of the ABT
1 Connect the PC to a switch.
2 Referring to Configuring a Client PC to Configure the ABT’s Network Settings , on
page 93, configure the PC with the following network settings:
3 Apply power to the Audio Bridge Terminal and make sure it is connected to the same
switch as the PC.
• If the switch is Power over Ethernet (PoE) enabled, simply connect it to the unit
using an Ethernet cable.
• If not, PoE mid-span ( inserter ) equipment must be placed between the switch and
the Audio Bridge Terminal.
4 Press the RESET button (located on the right-hand side of the ABT rear panel beside the
ETHERNET/POWER RJ-45 connector) for at least 1 second.
The Audio Bridge Terminal will reboot with the following static network configuration:
Note:
The ABT is powered through the RJ45 Ethernet connector. There is no
power ON/OFF button, so the device is ON whenever a powered Ethernet
cable (PoE) is connected.
Property Setting
DHCP Off
Static IP address 10.0.0.1
Subnet mask 255.255.0.0
Default gateway 10.0.0.1