Belden Grass Valley KALEIDO-X16, Инструкция по установке и обслуживанию

Страница: 45 / 152

45
Kaleido-X16
Hardware Description & Installation Manual
Assigning an IP Address to Each Device in your System
Multiviewers and most peripheral devices that are part of a Kaleido-X16 system
communicate through a TCP/IP network. Configuring your system’s network parameters
includes the following:
• Assigning an IP address, and specifying the appropriate network mask, gateway
address, and a system name for each multiviewer. See Setting the Multiviewer’s IP
Settings Directly on the Monitor Wall , on page 45.
The Kaleido-X16 is shipped with the following default network settings:
• Configuring the Kaleido-RCP2, if available. See Configuring the Kaleido-RCP2 , on
page 88.
• Configuring the Audio Bridge Terminal (ABT), if available. See Configuring an Audio
Bridge Terminal , on page 91.
Setting the Multiviewer’s IP Settings Directly on the Monitor Wall
For the Kaleido-X16 multiviewer to join a TCP/IP network, it must be configured with an IP
address, a network mask, a gateway, and a system name.
The IP address, system name, and other parameters can be set via a control panel on the
monitor wall. The multiviewer has a USB at the front of the frame and two USB connectors
on the rear connector panel.
To change the multiviewer’s system IP address, and adjust your system’s configuration
1 Connect a mouse to one of the USB connectors of the Kaleido-X16.
2 Connect a keyboard to one of the USB connectors of the Kaleido-X16.
3 Right-click anywhere on the monitor wall. On the menu, point to Monitor wall , and
then click System Configuration .
System IP address 10.0.3.70
Network mask 255.255.0.0
Gateway 10.0.0.1
Note:
If the IP address of the multiviewer has been changed (i.e. it no
longer corresponds to the as-shipped configuration), it is still possible to
determine the current setting. To determine the IP address of your
Kaleido-X16 multiviewer, see Finding a Multiviewer’s System IP Address and
Application Version , on page 97.