Belden Grass Valley KALEIDO-X16, Инструкция по установке и обслуживанию

Страница: 93 / 152

93
Kaleido-X16
Hardware Description & Installation Manual
Configuring a Client PC to Configure the ABT’s Network Settings
The PC that you will use to communicate with the Audio Bridge Terminal must be
configured with an IP addresses that is within the same factory-default subnet used by the
Audio Bridge Terminal. The following procedure applies to a typical Windows 10,
Windows 8, or Windows 7 system.
To change the IP address of the client PC
1 Press the Windows key on your keyboard, type “control panel” and then press Enter.
2 In the search box, type “adapter”, and then, under Network and Sharing Center , click
View network connections .
3 In Network Connections , right-click the network adapter you wish to configure (e.g.,
Local Area Connection, or Ethernet ), and then click Properties . If the system prompts you
for an administrator password or confirmation, type the password or provide
confirmation.
The Properties window for the selected network adapter opens.
4 On the Networking tab, under This connection uses the following items , click
Internet Protocol Version 4 (TCP/IPv4) , and then click Properties .
The Internet Protocol Version 4 (TCP/IPv4) Properties window opens.
5 On the General tab, click Use the following IP address .