Belden GRASS VALLEY DENSITE 3+ FR4, Руководство пользователя

Страница: 28 / 59

16
Configuration
Pushing [ESC] moves the user back up to the previous menu level.
[HOME] Exits the current menu and returns the user to the HOME screen.
If no controls are operated for 30 seconds, the controller reverts to its normal operating status,
and the status display ceases flashing yellow and reverts to its normal operating mode.
Controller Status Indicator
The contoller status is displayed in the upper right side of the control panel, as a colored outilne
around the CTRL segment. The table shows how the various error conditions are flagged.
Alarm/Status Priority Display
Power supply failure 1 FLASHING RED
Fan failure 1 FLASHING RED
Internal error 2 RED
Normal (no errors) GREEN
LOCAL CONTROL SELECTED FLASHING YELLOW
The status display can show only one alarm/status, so it displays only the highest priority. For
example if there is an internal error, it should display RED. But if at the same time the chassis fan
has failed, then the LED will display FLASHING RED.
Be aware that a high priority alarm can mask a lower priority one.
Using the Controller’s web page
The controller serves a web page from it’s ETH1 port. The web page provides complete configu-
ration utilities for the controller itself.
To use this resource, you must be able to connect to the controller. The controller is shipped
with these default IP addresses on its ports:
ETH1 ETH2
IP address 192.168.3.3 192.168.4.3
Network Mask 255.255.255.0 255.255.255.0
Gateway 0.0.0.0 0.0.0.0
You will need to change these to fit your local network.
• You can change them from this web page, or through the local control panel menu, but
not through the iControl interface.
To access the CPU-ETH3 controller web page
1 Open a Web browser window and enter your CPU-ETH3’s IP address in the address bar.
The home page of the CPU-ETH3 Web client appears.