Belden GRASS VALLEY DENSITE 3+ FR4, Руководство пользователя

Страница: 25 / 59

13
Configuration
Summary
Using the Ethernet interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Using the local control interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Using the Controller’s web page . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Configuring the CPU-ETH3 Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Upgrading the CPU-ETH3 Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
Configuring the Frame Reference . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
Control Interfaces
The CPU-ETH3 controller is the control point for the Densité 3+ FR4 frame and the Densité-series
cards installed in the frame. There are no separate operating controls on the frame or cards.
There are three ways to configure the controller, as explained below.
Using the Ethernet interface
The CPU-ETH3 controller supports remote operation through two rear-panel 100Mbps / GigE
ethernet ports, using Grass Valley’s iControl. The command set available for communicating
with a DENSITÉ frame permits more complex and comprehensive control, parameter storage,
and field upgrading than is supported by the local control panel.
The operation of the CPU-ETH3 card can be controlled using Grass Valley’s iControl system. This
manual describes the control panels associated with the CPU-ETH3 and their use.
Please consult the iControl User’s Guide for information about setting up and operating
iControl.