Section E. Unitizing Belarus-510/512 — Operating manual
53
Additional suspension axles of
lower rods of hitch mechanism
When processing high-stalk crops, install
the lower rods (3) to additional suspension
axles. At that, to partially lock the machine
in the working position, attach the limit
chains (2) to the hole of the bracket (1)
third from the bottom and to fully lock — to
the fourth hole.
In the transportation position, lock is pro-
vided automatically.
Haul-and-draw coupler
ТСУ
-1
Ж
(cross-
piece) (4)
The haul-and-draw coupler is used to at-
tach machines working at speeds not ex-
ceeding 15 km/h/ Tractors are shipped
from the factory with the cross-piece in-
stalled as shown in Fig. I. To re-set from
the transportation position (I) to the working
position (II), proceed as follows:
1. Unsplint and take out the eye (3), re-
move the cross-piece (4).
2. Unsplint and take out the finger (2), re-
move the back ends of the lower rods (5).
3. Install the cross-piece (4) to the front
ends of the lower rods (1), fasten it with
the eye (3) of the limit chains, fingers (2)
and splints (see Fig. II).
With outer or inner installation of limit chains,
ensure a full lock of the haul-and-draw cou-
pler. When installing a haul-and-draw coupler
with telescopic rods, attach them to the bracket
hole second from the bottom and ensure a full
lock.
ATTENTION!
It is forbidden to use the
haul-and-draw coupler forks to work with
trailers at a speed exceeding 15 km/h.
IMPORTANT!
Make sure that the haul-
and-draw coupler is locked from side os-
cillation by adjusting the inner or outer
rods.
IMPORTANT!
Make sure that the haul-
and-draw coupler is locked from side os-
cillation by adjusting the inner or outer
rods.
