Section E. Unitizing Belarus-510/512 — Operating manual
47
To inscrease the road clearance when pro-
cessing long-stalk crops, install the front
ends of the lower rods to additional suspen-
sion axles located by 110 mm above the
lower rod axle. To copy the floor profile in
the transverse direction while working with
wide-cut implements, link the braces (1)
with the lower rods (2) through the longitu-
dinal grooves.
IMPORTANT!
The brace forks must be
behind the hole to avoid damage to the
brace.
Upper rod and braces
The upper rod length can be adjusted from
500 to 740 mm. The length of the adjusta-
ble right brace can be adjusted from 425 to
520 mm by turning the handle (1). When
shipped from the factory, the right brace
length is set to the standard value of 475
mm. The length of the right (unadjustable)
brace is also set to the standard value of
475 mm when the tractor is shipped from
the factory.
During operation, the left brace length can
be changed from 395 to 510 mm depend-
ing on the tractor delivery set and kind of
attached machines and equipment.
IMPORTANT!
Adjust an implement in
the transverse plane only with the right
brace.
Depending on the plowing depth and soil
nature, set the upper rod in one of the three
positions:
I — light soils and small plowing depth at
power control;
II — medium soils and medium plowing
depth at power control;
III — heavy soils at a bid plowing depth, as
well as at position control or without use of
power regulator.
425-520
110 mm
