Section E. Unitizing Belarus-510/512 — Operating manual
50
Partial lock of telescopic rods
ATTENTION!
The telescopic rods must be
installed only to the hole that is second
from the bottom.
To ensure the desired side movement of
the machine, ex. plow, in the working posi-
tion, adjust the rods as follows:
• turning the screw (2), set the handle (3) to
the middle of the flat “B”;
• remove the cotter (5) from the rod;
• attach the machine to the lower rods (7)
and lift it off the ground;
• aligning the hole in the inner pipe (4)
with the groove of the pipe (6), insert the
cotter (5) in the middle of the groove.
IMPORTANT!
Install the cotter (5) so
that it be in the middle of the groove or
slightly closer to the tractor. Otherwise
the rods may be damaged.
Before a transportation journey, raise the
machine to the upper position and check
its side oscillation that must not exceed
20 mm to any side. If necessary, adjust
the oscillation magnitude turning the screw
(2).
Fully locking rods
To fully lock machines, ex. a cultivator or a
trailed device, in the working position ad-
just the rods similarly to the partial lock,
except for the last operation, at which align
the hole of the inner pipe (4) with the hole
of the outer pipe (6) and insert the cotter
(5) into the holes.
Ensure a full lock in the transportation posi-
tion (with the machine lifted) by screwing
the screw (2) into the pipe (4) to the maxi-
mum extent possible.
