FLIPPING™ ARCH
1MANUL027
Belanger®, Inc. *PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
5
Introduction
IMPORTANT Safety Information
– MUST READ
Safety Warnings
DISCONNECT THE MAIN POWER SUPPLY AND
DISSIPATE ALL POTENTIALLY HAZARDOUS
ENERGY SOURCES PRIOR TO SERVICING OR
MAINTAINING EQUIPMENT
Belanger® recommends that all workers observe the OSHA (U.S. Department of
Labor Occupational Safety & Health Administration) Lockout / Tagout procedure
to dissipate all potentially hazardous energy sources (i.e. - electrical, mechanical,
hydraulic, pneumatic, chemical, thermal, etc.) prior to performing service or
maintenance on machinery and equipment.
Note:
Reference the OSHA standard for the Control of Hazardous Energy (Lockout/Tagout), Title 29
Code of Federal Regulations (CFR) Part 1910.147 and the example provided in 1910.147
Appendix A for practices and procedures necessary to disable machinery or equipment, thereby
preventing the release of hazardous energy while employees perform servicing and maintenance
activities. The standard outlines measures for controlling hazardous energies – electrical,
mechanical, hydraulic, pneumatic, chemical, thermal, and other energy sources.
Note:
Reference the OSHA standard 29 CFR 1910.331 to 29 CFR 1910.335 for safe work practices to
protect employees working on electrical circuits and equipment. This section requires workers to
use safe work practices, including lockout and tagging procedures. These provisions apply when
employees are exposed to electrical hazards while working on, near, or with conductors or systems
that use electrical energy.
Note:
Both referenced OSHA standards can be found at the following website:
. Browse to the General Industry tab under the Find an OSHA Standard heading, scroll
down to the link of interest and click on it.
Doing so will prevent unexpected energization, startup, or release of hazardous
energy while maintenance and servicing activities are being performed.
