Beko BEKOMAT 33iU, Оригинальное руководство по установке и эксплуатации

Страница: 20 / 68

3.4.3.3 Changing interface parameters
INFORMATION BEKO TECHNOLOGIES configuration tools!
i
BEKO TECHNOLOGIES recommends using the Software Integrator to change the interface
parameters. The software can be downloaded from the BEKO TECHNOLOGIES homepage
(see “1.1 Contact” on page 5).
To connect to a PC,
BEKO TECHNOLOGIES recommends using the Integrator Hardware Kit
(for ordering information, see chapter “11.2 Accessories” on page 55).
This process is used to change interface parameters required for communication.
1. Write the value 0xAC1D (decimal: 44061) to Holding Register 0x1392 (Decimal: 5010).
2. Write the parameter to the Holding Register 0x07D0 (decimal: 2000).
Description / explanation
HighByte: See the following table
LowByte: Modbus Client address 1 … 246
Example value: 0x070A (decimal: 1802)
For interface parameters see table Index 0x07 (decimal: 7)
Client Address 0x0A (decimal: 10)
3. To save the settings, write the value 0xBA5E (decimal: 47710) to Holding Register 0x139C (Decimal: 5020).
4.
Switch the product off and switch it back on again.
0 The changes will go into effect approx. 10 seconds after the restart.
Parameter - HighByte Parameter - HighByte
Selection
Baud
rate [Bd]
Parity Stop Bit Selection
Baud
rate [Bd]
Parity Stop Bit
0x00 4800 No 2 0x0C 57600 No 2
0x01 4800 Even 1 0x0D 57600 Even 1
0x02 4800 Odd 1 0x0E 57600 Odd 1
0x03 9600 No 2 0x0F 76800 No 2
0x04 9600 Even 1 0x10 76800 Even 1
0x05 9600 Odd 1 0x11 76800 Odd 1
0x06 19200 No 2 0x12 115200 No 2
0x07 19200 Even 1 0x13 115200 Even 1
0x08 19200 Odd 1 0x14 115200 Odd 1
0x09 38400 No 2
0x0A 38400 Even 1
0x0B 38400 Odd 1
BEKOMAT
®
33iU / 33iU CO Original installation and operation manual
20 | 68