EN
34
Descaling with the BEEM Premium Descaler Concentrate
1. Fill the water reservoir (
5
) up to the
MAX
marking with a concentrate/water solution of
no more than 1:20 (one part concentrate to 20 parts water).
2. Set the On / Off switch (
9
) on the bottom of the base (
7
) to Position
I
(on) in order to
turn the device on. The operating lamp in the On / Off switch lights up.
3. Turn the thermostat control (
6
) clockwise until it resists to start the heating process
and to bring the solution to a boil. The control lamp (
10
) lights up blue. The solution
starts boiling.
4. As soon as the solution comes to a boil, turn the thermostat control counter clockwise
so that the control lamp goes out (see the “Preparation” chapter | “Interval Boiling”).
Let the solution take effect for a little while.
5. Allow the solution to run through the discharge tap (
11
) so that it is also freed of any
limescale residues (see the “Operation” chapter | “Operating the Discharge Tap”).
6. To rinse the device, allow two tankfuls (about 5 litres) of clear water to run through it.
The device is now descaled and ready to be used again.
Storage
Disconnect the device from the mains power when it is not going to be used for a
prolonged period. Clean the device again (see the “Cleaning and Care” chapter) to avoid
possible mould formation. Mould can cause spots and damage on the device that can no
longer be removed / repaired. Allow the device and all accessories to dry completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from
direct sunlight and cannot be accessed by children or animals.
