Beckhoff eXtended Transport System, Руководство по эксплуатации

Страница: 65 / 114

Mechanical installation
Version: 2.2 ─── 65 XTS
Assembly with alignment
gauge [+]
Assembly with alignment gauge [+] (ordering option)
The alignment gauge is not included in the standard scope of deliv-
ery. Beckhoff recommends the use of the alignment gauge for the
assembly of the straight modules.
If you don't use an alignment gauge you can use, for example, a
vernier caliper instead.
Use the alignment gauge to align the modules at the specified dis-
tance between the locating pins. The distance from the center of the
first locating pin to the center of the first locating pin in the attached
module is 250 mm.
1
2
► Place the alignment gauge 1 on top of two adjacent modules 2
1
2
3
► Make sure that the marking 1 is placed in the center between
two modules
Important
If the alignment gauge is placed the wrong way around, the align-
ment gauge will overhang at the side of a module and the marking 1
will not be in the center of the modules.
► Screw the screw and washer 2 hand tight into the center of the
module 3