Beckhoff EL3182, Документация

Страница: 86 / 145

Commissioning
EL3182 86 Version: 1.2
5.3.3 Input data
Index 0x60n0 AI Inputs (n=0: Channel 1, n=1: Channel 2)
Index
(hex) Name Meaning Data type Flags Default
60n0:0 AI Inputs Maximum subindex UINT8 RO 0x11 (17
dez
)
60n0:01 Underrange Value below measuring range BOOLEAN RO 0x00 (0
dez
)
60n0:02 Overrange Measuring range exceeded BOOLEAN RO 0x00 (0
dez
)
60n0:03 Limit 1 Limit value monitoring Limit 1
0: not active
1: value is smaller than limit value 1
2: value is larger than limit value 1
3: Value is equal to limit value 1
BIT2 RO 0x00 (0
dez
)
60n0:05 Limit 2 Limit value monitoring limit 2
0: not active
1: value is smaller than limit value 2
2: value is larger than limit value 2
3: Value is equal to limit value 2
BIT2 RO 0x00 (0
dez
)
60n0:07 Error The error bit is set if the data is invalid
(over-range, under-range) BOOLEAN RO 0x00 (0
dez
)
60n0:0E Sync error The Sync error bit is only required for
DC mode. It indicates whether a
synchronization error has occurred
during the previous cycle.
This means a SYNC signal was
triggered in the EL31xx, although no
new process data were available
(0=OK, 1=NOK). BOOLEAN RO 0x00 (0
dec
)
60n0:0F TxPDO State Validity of the data of the associated
TxPDO (0 = valid, 1 = invalid) BOOLEAN RO 0x00 (0
dez
)
60n0:10 TxPDO Toggle The TxPDO toggle is toggled by the
slave when the data of the associated
TxPDO is updated BOOLEAN RO 0x00 (0
dez
)
60n0:11 Value Analog input date INT16 RO 0x0000 (0
dez
)
5.3.4 Information and diagnostic data
Index 0x80nE AI Internal data (n=0: Channel 1, n=1: Channel 2)
Index
(hex) Name Meaning Data type Flags Default
80nE:0 AI Internal data Maximum subindex UINT8 RO 0x01 (1
dez
)
80nE:01 ADC raw value ADC raw value INT16 RO 0x0000 (0
dez
)