
Device Configuration
Interface Setup – Wireless
52
BEC MX-210NPV User Manual
Wireless
This section introduces the wireless LAN and some basic configurations.
NOTE: WLAN1 / 2 / 3 / 4 Interface refers to as SSID1 / 2 / 3 / 4 Wi-Fi networks.
Access Point Settings
Site Servey:
Click to view all other available Wireless-AP devices around the MX-210NPV.
CH (Channel)
: Channel ID used.
SSID
: The name of the wireless AP.
BSSID
: The MaC address of the wireless AP.
Security:
The security mode in the wireless AP.
Singal (%):
Singal strength of the wireless AP. Signal incrases means the wireless AP is closer
to your MX-210NPV and may cause interferences.
Access Point:
Default setting is set to
Activated
. If you want to close the wireless interface, select
Deactivated.
AP MAC Address:
The MAC address of wireless AP.
Wireless Mode:
The default setting is
802.11b+g+n
(Mixed mode). If you do not know or have both
11g and 11b devices in your network, then keep the default in
mixed mode
. From the drop-down
manual, you can select
802.11g
if you have only 11g card. If you have only 11b card, then select
802.11b
and if you only have 802.11n then select
802.11n
.
Channel:
The range of radio frequencies used by IEEE 802.11b/g/n wireless devices is called a
channel. There are Regulation Domains and Channel ID in this field. The Channel ID will be different
based on Regulation Domains. Select a channel from the drop-down list box.