MPS 500 – User Manual Rev. 2.1
BeamTec GmbH
Wolfgang-Paul-Str. 4, 89081 Ulm, Germany
http:
, e-mail: [email protected] tel.: +49 731 146620-0
54
5.
A
DDITIONAL
I
NFORMATION
5.1
N
O
I
NTERLOCKS CONNECTED
If there is no interlock connected, switching to operating mode ( HV ON ) is not
possible – ‘No Interlock’ message will appear – Fig. 5.1.0
Fig.5.1.0
This information stays on the display until ESC button is pressed.
Hardware Interlock wiring has been described in section 3.3.5
5.2
I
NTERLOCK LOST DURING THE NORMAL OPERATION
If the power supply is operating in HV ON mode when the interlock will be lost, the
unit will be automatically set to STANDBY mode – HV OFF, and the following message
will appear:
Fig.5.1.1
This information stays on the display until ESC button is pressed.
Hardware Interlock correct hardware wiring has been described in section 3.3.5
No Interlock !!!
Interlock Lost!
HV Off
