BE BE3500IP, Руководство пользователя

Страница: 32 / 80

32
8.2 Engine
Perform the following steps to protect the cylinder, piston ring, etc.
from corrosion.
1. Remove the spark plug, pour about one tablespoon of SAE 10W-30
into the spark plug hole and reinstall the spark plug. Recoil start the
engine by turning over several times (with 3 in 1 switch knob off) to
coat the cylinder walls with oil.
2. Pull the recoil starter until you feel compression, then stop pulling.
(This prevents the cylinder and valves from rusting).
3. Clean exterior of the generator. Store the generator in a dry,
well ventilated place, with the cover placed over it (cover sold
seperately).
9. TROUBLESHOOTING
9.1 Engine won’t start
1. Fuel systems No fuel supplied to combustion chamber.
· No fuel in tank…Supply fuel.
· Fuel in tank….Fuel tank cap and fuel knob to “ON”
· Clogged fuel filter …. Clean fuel filter.
· Clogged carburetor…. Clean carburetor
2. En
gine oil system Insufficient
· Oil level is low…. Add engine oil.
3 . Electrical systems
· Put the 1 in 3 switch to “CHOKE” and pull the
recoil starter … Poor spark.
· Spark plug dirty with carbon or wet … Remove carbon or wipe spark
plug dry.
· Faulty ignition system … consult our company authorized dealer.
TROUBLESHOOTING
9.2 Generator won’t produce power
• · Safety device (DC protector) to “OFF”…. Press the DC protector to
“ON”.
• · The AC pilot light (Green) goes off …. Stop the engine, then restart.
the carburetor float chamber.
6. Turn the 3 in 1 switch to “OFF”.
7. Tighten the drain screw.
8. Install the cover and tighten the screws.