BE BE3500IP, Руководство пользователя

Страница: 30 / 80

30
The engine should never run without the foam element;
excessive piston and cylinder wear may result.
7. Instal l the air filter case cover in its original position and tighten the
screw.
8. Install the cover and tighten the screws.
7.6 Fuel tank filter
WARNING
• Never use the gasoline while smoking or in the
vicinity of an open flame.
1. Remove the fuel tank cap and filter.
2. Clean the filter.
3. Wipe the filter dry and reinstall it.
4. Install the fuel tank cap.
Be sure the fuel tank cap is tightened securely.
MAINTENANCE
1. Remove the screws (1).
2. Remove the muffler cap (2), the muffler screen (3) and the spark
arrester (4).
3. Clean the carbon deposits on the silencer screen and the spark
arrester with a wire brush.
4. Check the muffler screen and the spark arrester. Replace if
damaged.
5. Reinstall the spark arrester.
7.5 Muffler Screen and Spark Arrester
- 0 3 -
r e t s e r r a k r a p s d n a n e e r c s r e lf f u M 5 . 6
The engine and muffler will be very hot after the engine has been run.
Avoid touching the engine and muffler while they are still hot with any
part of your body or clothing during inspection or repair.
1. Remove the screws
①,
2. Remove the muffler cap , the muffler screen and spark arrester
3. Clean the carbon deposits on the muffler screen and spark arrester using a
wire brush.
4. Check the muffler screen and spark arrester. Replace them if damaged.
5. Install the spark arrester.
TIP: Align the spark arrester projection with the
hole in the muffler pipe.
When cleaning, use the wire brush lightly to avoid damaging or scratching
of muffler screen and spark arrester.
②
③ ④.
②
①
③
④
- 31 -
6. Install the muffler screen and the muffler cap.
7. Install the cover and tighten the screws.
6.6 Fuel tank filter
Never use the gasoline while smoking or in the
vicinity of an open flame.
1. Remove the fuel tank cap and filter.
Fuel tank cap
2. Clean the filter with gasoline.
3. Wipe the filter and install it.
4. Install the fuel tank cap.
Be sure the fuel tank cap is tightened securely.
6.7 Fuel filter
1. Remove the screws
①,
and then remove the cover
②,
and drain the fuel
③
2. Hold and move up the clamp
④,
then take off the hose
⑤
from the tank.
②
1
3. Take out the fuel filter .
4. Clean the filter with gasoline
.
5. Dry the filter and put it bank into tank
.
6. Install the hose and clamp, then open the fuel valve to check whether it is
leak
.
7. Install the cover and tighten the screws.