![background image](http://html1.mh-extra.com/html/bayrol/poolmanager-bromine/poolmanager-bromine_user-manual_2713057079.webp)
44
Network connection
User Manual PoolManager
®
79
44
Network connection
Requisite user qualification:
IT SPECIALIST
The network connection may only be performed by an
IT SPECIALIST as defined in the chapter
User
qualification.
PoolManager
®
offers comprehensive and very comfortable
opportunities for remote access from a local network or from the
Internet.
In order to use these opportunities, PoolManager
®
has to be
connected to a TCP/IP network (TCP/IP is the transmission protocol
used on networks and the Internet).
In the PoolManager
®
terminal box, there is a standard Ethernet slot
(RJ45).
A standard network cable (Cat5 or Cat6) can be plugged
into that slot.
The network cable is fed through a special large cable fitting into the
terminal box in order to maintain IP65 rating.
44.1
Step by step
1.
Turn off PoolManager
®
power supply.
2.
Loosen the four screws on the terminal box cover and remove
it.
3.
Loosen the large cable fitting on the far left.
4.
Feed a standard network cable with an RJ45 plug into the
terminal box as shown in the following figures.
5.
Next, run the cable through the cable fitting's cover and through
the fitting itself.
6.
Plug the cable into the RJ45 slot.
Be sure the plug connection locks securely
7.
Pull the slotted rubber seal over the cable as shown in the
figure.
8.
Press the rubber seal into the cable fitting.
9.
Screw the cable fitting tight again in order to obtain a reliable
seal.
10.
Close the casing again. Tighten the screws on the terminal box
cover by hand in order to obtain a reliable seal.
11.
Turn PoolManager
®
voltage supply on again.