Bay Tek Games Crank It Revolution, Руководство по обслуживанию

Страница: 24 / 49

TROUBLE SHOOTING GUIDE
Problem Probable Cause Remedy
Scoring
Issues
Game shows
“Spin now”
and “Hurry up”
Encoder sen-
sor not seeing
wheel spin.
Encoder sensor dirty or
faulty.
Sensor is being interfered
with.
Pinched, broken, or discon-
nected wiring.
Faulty Main Board
Clean sensor and replace if needed.
(AACB8852)
Remove game from direct sunlight,
move game to area away from neon
lights or bright fluorescent lights.
Inspect wiring and replace cable if
needed. AACB8852, AACE8851
Refer to Encoder Sensor Test below.
Game says you won
even though wheel is
still spinning. Brake Assembly tension set to
loose.
Refer to
“How to Set Brake Tension”
Wheel values, arrow
pointer and payout are
off slightly. There is an adjustment on the
wheel encoder sensor to cali-
brate the monitor change to
where the arrow is pointing.
Refer to
“How to adjust wheel sensor”
Game is giving wrong
tickets values.
Enter Diagnostic Menu on
MENU 6
and watch dot matrix dis-
play as you spin the wheel
downward.
*
Remove game from direct
sunlight, move game to area
away from neon lights or
bright fluorescent lights.
Wheel Position does
not
change as you spin the wheel
down.
Encoder sensor unplugged, dirty or faulty.
Clean and replace if needed.
(AACB8852)
Inspect wiring, refer to Encoder Sensor Test
below.
If Wheel Position goes to 24, then resets to 0
and continues up again.
Encoder sensor out of adjustment.
Refer to
“How to adjust wheel sensor”
If Wheel Position increments constantly upwards
up past 100.
Home Position sensor
unplugged, dirty or faulty.
Clean and replace if needed.
(AACB4403)
Inspect wiring.
Cable #’s AACE8854, AACE8850
Wrong ticket pattern selected. Enter menu and
go to MENU 2. Verify correct ticket pattern.
Wheel Position does change
as you spin the wheel down.
Display shows
“LOW TKTS”
Ticket tray is empty.
Disconnected, loose or broken
wires.
Faulty low ticket switches.
Faulty Main Board.
Refill tray with tickets, check low ticket switch.
Check connections and reseat J25 on main
board. Cable #’s AACE8852, AACE8853
Switches wired normally open. Replace switches.
A5SW200
Replace main board. Part # AANEWGEN1
24