Bay Tek Games Crank It Revolution, Руководство по обслуживанию

Страница: 23 / 49

TROUBLE SHOOTING GUIDE
Troubleshooting Strategy
Use common sense and a systematic method of troubleshooting to determine the exact problem, probable cause and
remedy. Use the process of elimination to find the faulty component. Always check for the simple and obvious causes
first such as unplugged, loose or broken wires and bad sensors, bent, pinched, stuck or jammed components.
Troubleshooting Chart
Problem Probable Cause Remedy
No power to the game.
No lights on at all.
Unplugged.
Circuit breaker tripped.
Power strip faulty.
Faulty cable/power supply.
Check wall outlet.
Reset power strip breaker switch or building
circuit breaker.
Change plug position, replace if needed.
See Power Supply diagnostic below.
AC Light and Bill Acceptor
on; everything else off.
(Power Supply not ON)
Ensure unit is plugged
into power strip.
Make sure rocker switch is
set to ON.
See power supply diagnostics to isolate bad
component. A bad motor or 12 volt short
would cause this.
See Power Supply Diagnostic below.
Dollar Bill Acceptor not
functioning.
Ensure Bill Acceptor is set to
“Always Enable”
Check for power to Bill
Acceptor.
Dirt or debris in acceptor
slot.
Pinched, broken, or
disconnected wiring.
Bill acceptor problem.
Acceptor should cycle stacker at game
power up. If not, check cable connections.
Refer to “How to Clean Bill Acceptor”
Or clean with bill reader cleaning card.
(A5CC9000)
Check wiring from bill acceptor
to Main Board. (AACE8862)
Repair or replace wiring harness.
Check J8 connector on Main Board
Make sure wires are secure in connectors.
Refer to troubleshooting section of dollar bill
acceptor manual included with this game or
the diagnostics label on the back of the unit.
Power supply unplugged.
Rocker Switch turned off.
Power supply shutting down
because of 12 V overload.
Faulty power supply.
Game not coining up.
Ensure game makes sound
when coin switch is triggered.
Game set to large amount of
credits per game. Check coin switches—both should be wired
normally open. If one switch is “closed” the
other will not work either.
Check wiring to main board.
Cable AACBL4A-DOOR, AACE8850
Jackpot display will show credits inserted.
Enter N1 mode in menu to set credits per
game.
23