Baroness TDA1200, Руководство по обслуживанию

Страница: 78 / 89

Apply liquid gasket to both sides of
packing B. Position and attach to crank
gearbox A.
Align and attach crankshaft housing to
crank gearbox A. Secure with bolts and S
washers (finger-tighten).
1
3
2
4
5s6or7-080
Inspection of gear box_053
1 Packing B
2 Crankshaft housing
3 Crank gearbox A
4 Bolt, S washer
Tighten the bolts in the pattern shown by
the torque 29 - 38 N-m (295.71 - 387.49
kgf-cm).
Check that drive shaft C turns.
1
5s6or7-081
Inspection of gear box_054
1 Bolts, S washers
49.
[1]
[2]
50.
[1]
[2]
Place bearing into crank gearbox A. Use
driving tool to set into position.
Install stop ring. Make sure stop ring is
positioned correctly and fully sitting in
groove. Flat side of stop ring should be
facing away from bearing.
3
2
1
5s6or7-082
Inspection of gear box_055
1 Crank gearbox A
2 Bearing
3 Stop ring
Apply the gear oil to the lip of the oil seal.
Apply liquid gasket or sealant to outer
side of oil seal.
Carefully position oil seal and tap flush
into the crank gearbox A with driving tool.
1
5s6or7-083
Inspection of gear box_056
1 Oil seal
51.
[1]
[2]
52.
[1]
[2]
[3]
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-56
Inspection and repair of each section