Baroness TDA1200, Руководство по обслуживанию

Страница: 70 / 89

Remove the stop ring securing drive shaft B
and bearings from inside of crank gearbox
A.
1
3
2
5s6or7-047
Inspection of gear box_018
1 Crank gearbox A
2 Drive Shaft B
3 Stop ring
Apply 2 M20 washers to threaded side of
drive shaft C and fasten M20 nut.
[This is to protect the threaded portion of
drive shaft C]
Tap lightly on crank shaft C with a wood
hammer until a gap or space is created
between the crankshaft housing and
crank gearbox A.
1
2
5s6or7-048
Inspection of gear box_019
3
4
5s6or7-049
Inspection of gear box_020
17.
18.
[1]
[2]
1
Nut (TDA1200 use M20, TDA1600 use
M24)
2
Washer (TDA1200 use M20, TDA1600
use M24)
3 Drive shaft C
4 Crankshaft housing
Using a box-cutter or long blade cut away
at packing and sealant between crankshaft
housing and crank gearbox A.
3
1
2
5s6or7-050
Inspection of gear box_021
1 Box-cutter
2 Packing
3 Crank gearbox A
Important
When you put a scratch on the crankshaft
housing and or the crank gear box it may
cause an oil leakage.
Can cover tips of screwdrivers with electric
tape or similar to aid in prevention of
scratching surfaces.
Using one or two flathead screwdrivers,
carefully pry little by little while changing
location to remove the crankshaft housing.
1
2
5s6or7-051
Inspection of gear box_022
1 Crankshaft housing
2 Flathead screwdriver
19.
20.
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-48
Inspection and repair of each section