Baroness TDA1200, Руководство по обслуживанию

Страница: 48 / 89

Remove the tine holder, lower housing A,
and lower housing B, and then remove the
collar.
1
2
4
3
lyl9n4-004
TDA1200_004
1 Tine holder (with a bearing)
2 Lower housing A (with a bearing)
3 Lower housing B (with a bearing)
4 Collar
Remove the bearing, bearing collar, lower
arm and lock plate from the arm axis.
1
1
2
1
2
2
4
3
5
lyl9n4-005
TDA1200_005
1 Bearing
2 Bearing collar
3 Lower arm
4 Lock plate
5 Arm axis
Fasten the tine holder (with a bearing) on
the vice and then remove its bearing.
5.
6.
7.
Remove bearings from the lower housing
A (with a bearing) and the lower housing B
(with a bearing), too.
1
2
lyl9n4-006
TDA1200_006
1 Tine holder (with a bearing)
2 Vise
Caution
"Tightening torques" (Page 3-4) See the list.
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
Important
Be sure to replace the bearings, disc springs
and U nuts with new ones.
Install the lock plate on the arm axis.
Lap the lower arm over from the above.
Important
Install the bearing collars with taking care of
their correct directions.
Insert the bearing collars into each
appropriate arm axis.
1
3
2
4
UP
5
lyl9n4-007
TDA1200_007
8.
9.
10.
11.
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-26
Inspection and repair of each section