Baroness LM315GC, Руководство по эксплуатации для владельца, Страница: 40 / 86

Adjustment of Cutting Height
Adjust the cutting height to fit your cutting work.
Important
This applies the set cutting height that differs
from the actual cutting height.
Adjustment of Rear Roller
LM315GC (for greensmowing)
You can adjust the rear roller by six stages.
Attach the rear roller in a position that
suits your work requirements within the
cutting height range.
Note:
The figure below shows the position of
the rear roller bracket with a new reel
cutter using 1.5 mm bed knife.
The lowest cutting height differs with
thickness of the bed knife. "Cutting
Height and Blade Thickness of Bed Knife
(Bottom Blade)" (Page 4-20)
1
2
3
A B C
D E F
3kws2a-008
Adjustment of Rear Roller_001
1 Mower frame
2 Rear roller bracket
3 Rear roller
A Use when the reel cutter is worn out
B 1.5 - 5.0 mm (0.059 - 0.197 in)
C 1.5 - 10.0 mm (0.059 - 0.394 in)
D 10.0 - 14.0 mm (0.394 - 0.551 in)
E 14.0 - 18.0 mm (0.551 - 0.709 in)
* F 18.0 - 20.0 mm (0.709 - 0.787 in)
Not recommended by manufacturer.
Note:
If the cutting height was the same with
settings B and C, the volume of mowing
would be larger with C since the offset
distance is larger.
1.
*
LM315GC (for tee mowing)
You can adjust the rear roller by eight
stages.
Attach the rear roller in a position that
suits your work requirements within the
cutting height range.
Note:
The figure below shows the position of
the rear roller bracket with a new reel
cutter using 3.0 mm bed knife.
The lowest cutting height differs with
thickness of the bed knife. "Cutting
Height and Blade Thickness of Bed Knife
(Bottom Blade)" (Page 4-20)
1
2
3
A B C
D
E F
G H
3kws2a-011
Adjustment of Rear Roller_003
1 Mower frame
2 Rear roller bracket
3 Rear roller
A Use when the reel cutter is worn out
B 6.0 - 13.0 mm (0.236 - 0.512 in)
C 13.0 - 17.0 mm (0.512 - 0.669 in)
D 17.0 - 20.0 mm (0.669 - 0.787 in)
* E 20.0 - 25.0 mm (0.787 - 0.984 in)
* F 25.0 - 28.0 mm (0.984 - 1.102 in)
* G 28.0 - 32.0 mm (1.102 - 1.260 in)
* H 32.0 - 35.0 mm (1.260 - 1.378 in)
Not recommended by manufacturer.
1.
*
LM315GC
Handling Instructions
Page 4-16
Adjustment Before Operating