Bard FUSION-TEC WR Series, Сборник литературы

Страница: 21 / 102

Manual 2100-704C
Page 19 of 47
FIGURE 14
Wire Routing
The main unit circuit breaker disconnect access is
located on the front panel of the unit. Located at the
upper right corner of this panel is the rubber circuit
breaker boot. This allows unit power to be disconnected
without panel removal.
Route all field power wires in channel under the
control panel as shown in Figure 14. See Figure 15 to
reference VAC landing points.
LOW VOLTAGE
COMMUNICATION
WIRE ENTRANCE
HIGH VOLTAGE
POWER WIRE
ENTRANCE
MIS-3927
FIGURE 16
Side Communication and Power Wire Entrances (Recommended)
FIGURE 15
VAC Supply Wiring Landing Points
Route wires into unit through recommended side
entrances (see Figure 16). Optional rear entry points
are also available (see Figure 17 on page 20).
When running wires to unit from shelter, be careful to
not place wiring and conduit where it will interfere with
opening filter access doors.
Route communication wiring and
power supply wiring in their own
separate conduits. They must not
be run together.