![background image](http://html1.mh-extra.com/html/barco/dicom-theater/dicom-theater_system-manual_473991035.webp)
System manual DICOM Theater
36
When you click “Finish”, Windows may warn you that you must
restart your computer before the new settings will take effect. If it
does, we recommend restarting your computer now.
If you are using the VGA capabilities of your BarcoMed 2MP1HP
Display Controller, boot in VGA Mode when your system restarts, log
in using an account with administrator privileges and set the resolution
of your high resolution displays. If you do not boot in VGA Mode
Windows 2000 may pick a resolution that is not supported by your high
resolution display and you will need to reboot in VGA mode.
If you are not using the VGA capabilities of your BarcoMed 2MP1HP
Display Controller, boot normally when your system restarts, log in
using an account with administrator privileges and set the resolution of
your high resolution displays.
Setting the Resolution of Your 2MP1HP
1. To set the resolution for your high resolution display(s), right click
on the desktop and select “Properties”.
2. Select the “Settings” tab (see figure 13 on the next page). Select
the rectangle that represents the BarcoMed Display Controller you
are working with.
SPECIAL NOTE: If you are using the VGA capabilities of your
BarcoMed Display Controller, the resolution for that controller will
still be set to a VGA resolution of “640 x 480” pixels. If the
BarcoMed Display Controller is not running VGA, the device may
not be enabled yet. To enable the device check the “Extend my
Windows desktop onto this monitor” checkbox. Do not click the
“Apply” button at this time.
3. Click on the “Advanced” Button.
4. Select the “Adapter” tab and then click on the “List All Modes…”
button. Select the desired resolution and refresh rate that your high
resolution display supports from the dialog box and click “OK”.
5. Click “OK” on the bottom of the Adapter Control Panel. If the “OK”
button on the bottom of the Adapter Control Panel is not visible,
press the “Tab” key once and then “Enter” to select “OK”.
6. Click “OK” in the “Windows will now apply your new desktop
settings” dialog box. Your high resolution display should now
synchronize and display the Windows desktop.
7. Click “Yes” when asked, “Your desktop has been reconfigured. Do
you want to keep these settings?”
Содержание DICOM THEATER
