Barberan RP-30-FM1, Инструкция по эксплуатации

Страница: 11 / 129

MAQUINARIA PARA EL ACABADO DE SUPERFICIES MACHINERY FOR FINISHING SYSTEMS
The length of the veneer to be wrapped must be a few greater than the
length of the profile in order to avoid that the pressure rollers becomes dirty.
The adjustment of the veneer infeed respect to the profile is adjusted
through 2 time switches which are incorporated in the control board. The
time switch "veneer run" orders the introduction roller to descend. When the
time is increased the application of the veneer over the profile is delayed.
The descent of the introduction roller is produced only when the limit switch
situated upon the table of the application head is activated.
A second time switch called "veneer stop" orders to lift up the introduction
roller. The programmed time is the one which goes by from the activation of
the limit switch situated at the table of the head and the lifting up of the
introduction roller.
If the introduction roller is spotted with glue, make the glue cold on the roller
surface with compressed air. As soon the glue is cold it can be taken away
very easily.
PERIODICAL MAINTENANCE
For the good working and efficiency of the machine please rely on following
instructions :
- Maximal every week, as complement to the machine cleaning, all the
surfaces which do not have protection paint will be greased as for
example: the column guides or housings, elevation spindles, driving
chains, etc., except the surfaces in contact with the product. Any contact
with any grease has to be avoid rigorously. As lubricant medium normal
oils and grease for machinery will be used.
- All the ball or needle bearings are of permanent greasing. The
endless gears will be cleaned one time per year, lubricating them
with grease until approximately 1/3 of the inside space is full
Recommended greases
a) Fast displacement guides and spindles.(*)
- LAMORA D68 KLÜBER
- FEBIS K68 ESSO