Barberan RP-30-FM1, Инструкция по эксплуатации

Страница: 29 / 129

OLH is the percentage of time respect the cycle where the output
relay is closed when the heating is performed.
For example if we have fixed C=100 and OLH=65, that means that when a
heating is performed, from each 100 seconds, 65 seconds long will be the
heating elements ON, and 35 seconds long OFF (so it will heat at 65%
power).
If you want that it heats faster, increase the OLH value to heat during
longer time.
In case it works as Extruder, following parameters are guilty :
SP Adjustables Set Point. (Working port).
nnn “ Access key to the parameters.
Smrt On Shows the status of Smart
AL1 “ Limit of alarm 1.
HSA1 0.1 Hysteresis of alarm 1.
AL2 “ Limit of alarm 2.
HSA2 0.1 Hysteresis of alarm 2.
Pb Depending on manuf. Proportional band.
ti “ Integral time.
td “ Derivative time.
IP 30 Ramp
Cy1 60 Heating cycle time.
rL 0 Set Point lower limit
rH 250 Set Point upper limit
(permitted working temperature).
Grd1 Inf Gradient 1
Grd2 Inf Gradient 2
OLH “depending on machine” Max. Limit of the output power.
tOL “ Limitation time of the output power.
Rnp 25 Output control