Barberan RP-30-FM1, Инструкция по эксплуатации

Страница: 10 / 129

MAQUINARIA PARA EL ACABADO DE SUPERFICIES MACHINERY FOR FINISHING SYSTEMS
COMMISSIONING OF THE MACHINE WIT PU HEAD
- Check that the emergency stop buttons are unblocked and that the
security stop cable is tensioned.
- Check in the manometer the arrival of compressed air.
- Check that the pressure of the compressed air to the elements which are
to be used is adequate.
- Activate the electric main switch and the button "controls on". Push the
button to run the conveyor and adjust its speed according to the
characteristics of the profile, the wrapping and glue type to be used.
- When the wrapping is done with foil using PU glue, adjust the temperature
regulator of the evaporation tunnel and push the button to put in motion
the ventilators for the air circulation and the heating elements.
Activate the switch for the foil centring roller and verify the oscillation of
the centring roller.
Check the operation of the profile and foil heating screens leaving them
stopped until they are used.
ATTENTION
Do not manipulate the handwheel for speed variation when the conveyor
motor is not working as this would cause damages in the variator.
COMMISSIONING OF THE HOT MELT APPLICATION HEAD
The speed of the application roller must be adjusted to a value a few less
than the conveyor speed (approx. 1m/min slower) in order that the profile
pulls the veneer.