Barberan RP-30-FM1, Инструкция по эксплуатации

Страница: 7 / 129

MAQUINARIA PARA EL ACABADO DE SUPERFICIES MACHINERY FOR FINISHING SYSTEMS
INSTALLATION
Before the commissioning of the machine following operations have to be
done first :
- Remove the anti-oxidising protection and grease all those parts which are
not painted.
- Check the oil level of the speed variators.
- Situate the profile to be wrapped between the infeed guide wheels of the
machine with the main zone to be wrapped at the upper part and
approximately centred with the wheels.
- Open or close conveyor wheels in order that the profile is good supported
by them. At the wrapping zone it must be avoid that the conveyor wheels
disturb the application of the foil over the edges or lower surface of the
profiles. Close some wheels or take them away if necessary.
The adjustment of the guide wheels is done leaving a distance of 1 mm
between wheel and profile.
- Align the profile over the conveyor wheels in the whole run of the
machine until its outfeed. Place the lateral wheels which limit the width of
the profile to be wrapped. Align first the rollers placed at the right hand
side and the rollers placed at the left hand side. Give them a light
pressure over the profile in order that the roller moves themselves
approx. 1 mm.
Once the alignment of the profile is done, the upper wrapping rollers will
be adjusted, taking in account to make pressure over the profile in order
to comprise it approx. 1 mm.
- This adjustment begins putting the horizontal infeed roller to the wrapping
rollers which receives the glued foil or veneer over the top point of the
profile, adjusting then the wrapping rollers from the upper point to the