Barberan RP-30-FM1, Инструкция по эксплуатации

Страница: 22 / 129

b- Configuration:
Before starting the configuration of the controller, we just have to lose
the screw at the front of the instrument, extract it and we would be able to
put the switch V2 in open position (see drawing).
switch ope n
switch close d
Once the switch is open reinsert the instrument inside its box and
connect it. At the upper display will appear Cnf, this indicates that the device
is ready to be configured.
ATTENTION! If the instrument display the indication CAL, push immediately
the key “ARROW UP “ in order to return to the configuration procedure.
CAL indicates that the instrument is in calibration menu. This menu
shall not be modified as it has been adjusted at the factory.
Once Cnf appears we push the key FUNC and go on to configure the
different parameters. When on the screen appear the parameters to
configure, at the lower display the parameter that we are configuring will
appear, and at the upper display the parameter that we will modify. In order
to modify any parameter, we will proceed always the same way.
1.- Push the key “ FUNC “, so many times as necessary until the screen with
the parameter to be adjusted is reached.
2.- With the keys “Arrow up“ or “Arrow down“ modify the parameter until the
desired value is reached.
3.- Push the key “FUNC“ again in order to confirm the parameter.