Barbeques Galore G2CBL, Инструкция по сборке и эксплуатации

Страница: 32 / 57

Page 32
Assembly instructions (continued)
STEP 22: SHARING GAS SUPPLY BETWEEN ADJACENT MODULES:
All Cordon Bleu gas modules have independent gas supply, but it is
possible if required for only these combinations of maximum two
adjacent joined modules from the same gas supply:
2B and adjacent 4B can run from the same gas supply.
2B and adjacent 2B can run from the same gas supply.
2B and adjacent Range can run from the same gas supply.
4B and adjacent Range can run from the same gas supply.
Two adjacent Ranges can run from the same gas supply.
One side burner attached to any of these combinations is allowable.
WARNING: ANY OTHER COMBINATIONS OR EXTENDED COMBINATIONS IS NOT SAFE.
ONE GAS SUPPLY, HOSE AND REGULATOR ASSEMBLY MUST STILL BE USED FOR
INDIVIDUAL MODULES.
Adjacent (e.g. 6B) shared gas supply assembly:
WHAT YOU NEED
1 x separately supplied corrugated
gas pipe
(code CBGASEXT).
Take out the grease channelling trays. Using two spanners (one to hold the manifold, one to turn
the cap), disconnect the gas tube cap from the right side of the bbq on the left.
Using two spanners, (one to hold the manifold, one to turn the nut), disconnect the hose and
regulator from the left side of the bbq on the right.
(a) Remove the grease
channelling tray and use
two spanners to disconnect
the cap from the manifold
outlet, (one spanner to hold
the manifold, the other to
loosen the cap).
(b) Thread the corrugated gas pipe between the two bbqs as shown. Tighten the pipe
connections to each barbeque. Perform a leak test as outlined in following section under
“Safety leak testing”. You will need to bend the pipe a little to help guide it into place.