Barbeques Galore G2CBL, Инструкция по сборке и эксплуатации

Страница: 3 / 57

Page 3
Where to put your barbeque
This barbeque is an outdoor appliance only. Under no circumstances should it be used indoors.
You must observe the clearances listed on the data sticker on your barbeque. These tell you
how close you can put the barbeque to combustible surfaces (wood, gyprock, trees, wooden
fences etc.).
If you don’t follow these clearances, nearby surfaces will heat up and could catch
fire.
If you purchased your barbeque in a cart:
You don’t need to be concerned with side clearances. The barbeque-cart combination has been
laboratory tested, and complies with relevant Australian Standards.
Keep the barbeque sheltered from the wind. Wind interferes with the flames and can prevent
your barbeque from heating up properly and can even damage some components.
Make sure the surface is level. This is safer, and makes cooking easier.
Don’t put the barbeque too close to windows or anywhere else where cooking smoke is likely to
cause a problem.
For Build-In Barbeques and Islands:

Ensure you leave sufficient clearance underneath the barbeque for removal and cleaning
of grease channelling trays and receptacles.

For non-combustible build-in construction, leave a minimum 50 mm clearance behind the
barbeque and do not block any side or front vents on the barbeque to allow the appliance
to function properly. The 615 mm dimension below includes this 50 mm.

Ensure you leave sufficient space behind the barbeque to allow for the use of any
roasting hoods, in particular when they are in the fully opened position. See clearance
diagram below.

The distances from the barbeque to combustibles stated on the data plate must still be
observed.
When installing the barbeque into a dedicated structure, ensure that the following is
observed:
Width:
2B: 560 to 565 mm
4B: 880 to 885 mm
Min 310 mm
Min 615 mm
Cylinder cabinet top
and bottom ventilation
details as detailed
below must be
observed.
Bbq must be separated from the cylinder cabinet.
Min 45 mm rear clearance
to allow the hood to open