Page
4
Where to put your barbeque (continued)
Adequate clearance around the barbeque must be provided for safe and efficient
operation the clearances shown in the diagram below ensures that the burners have a
supply of fresh air to operate correctly. Failure to provide enough fresh air to the burners
can cause the production of potentially deadly noxious gases.
The structure must be made of non-combustible material. Also, you need to ensure that
there is a clearance of at least 300 mm between the sides and rear of the barbeque and
any combustible material (e.g. wooden fences and gyprock walls and painted surfaces).
If part of the structure is composed of combustible materials, ensure that the combustible
material is separated from the sides and rear of the barbeque by at least 300mm.
There must be at least 1000 mm vertically above the appliance and any combustible
material.
At least 45 mm clearance is required from the rear of the build-in barbeque support
bracket body to allow the roasting hood to open freely. When fully open, the hood leans
back slightly to prevent accidental closure.
In addition, where the cylinder is kept in an enclosed space underneath or near the build-
in barbeque, the following must be observed:
The cylinder must rest on a base to ensure that water will not accumulate, and that the
cylinder is clear of the surrounding soil.
There must be at least 200 square cm of ventilation openings per cylinder stored, at both
the top and bottom of the cylinder compartment, so that any accumulating gas can
quickly escape to the outside air. At least 50 square cm of the lower ventilation must be
within 15 mm of the base of the enclosure.
There must be a separation panel between the gas cylinder and the barbeque so that if a
high pressure gas leak occurs, there is no direct path between the cylinder compartment
and the bbq firebox.
Note that all these conditions are met by using prefabricated island
(code: PBIM4L)
available
from your local Barbeques Galore store.
Содержание G2CBL
