Baoli F Series, Руководство по эксплуатации и обслуживанию

Страница: 32 / 102

26
Engine compartment inspection
Engine coolant level check and
supply
(1) Reservoir tank
Level check and supply of engine coolant shall be performed
while the coolant is cool.
1. With the engine off, open the engine hood and check the
engine coolant level in the reservoir tank.
Note:
The reservoir tank equipped to the radiator automatically
supplies the engine coolant when the coolant quantity in the
radiator becomes insufficient.
2. The coolant level is proper if it is between the upper and lower
limits. If the level is below the lower limit, supply coolant to the
upper limit.
3. The concentration of the long life coolant (LLC) in the engine
coolant must be higher than 30% (or 50% in a frigid zone.)
Note:
If no engine coolant remains in the reservoir tank, be sure to
check the coolant level in the radiator, too.
Checking the engine coolant
level in radiator
(1) Radiator cover
1. Remove the radiator cover.
2. Remove the cap and check the coolant level from the filler
port.
3. If the engine coolant is not visible through the filler port, fill
appropriately diluted coolant (LLC) to the port.
Note:
To close and tighten the radiator cap, match the pawl on the
reverse side of the cap with the notch on the filler port and turn
the cap fully clockwise while applying a downward force.
Warning:
When the engine is hot, it is very dangerous to remove the cap.
Coolant level check must always be performed when the engine
is cold.
Checking hydraulic oil level
Always stop the engine and lower the fork to the ground before
checking the level of the hydraulic oil, while the vehicle is on
level ground.
1. Open the engine hood and remove the hydraulic oil cap.
2. Wipe the level gauge attached to the oil cap with clean cloth,
insert it again into the tank and screw tightly.
Note:
Inspect the oil level by placing the level gauge on the opening of
the oil supply inlet, without screwing the hydraulic oil cap tightly.
3. Extract the level gauge gently and check if the hydraulic oil
adhesion is up to the level line.
4. If the hydraulic oil level is insufficient, add oil. Spilled and
splashed oil must be wiped off thoroughly.