Baoli F Series, Руководство по эксплуатации и обслуживанию

Страница: 21 / 102

15
(4) Daily maintenance should be done before or after using the truck. Anytime you
find that the truck is not functioning normally, operation of the truck should be halted and
check or repair at once.
(5) When the distance between the gravity center of loads and the fork arms is
500mm, the max. capacity is the rated capacity. When the distance exceeds 500mm, the
capacity shall be reduced according to the load chart. Overloading is strictly prohibited.
(6) Operate your forklift truck on a hard ground. Operate on other ground, the lift
capacity and travel speed must be decreased. Wipe off the oil and grease from the floor.
(7) If the forklift truck is equipped with attachment, its usage sphere will be wider, but
its allowable load and stability is reduced. The attachment and special device is not to be
diverted to any other purpose. It’s very dangerous to rebuild the attachment. Please read
the additional instruction we supplied and operate the truck following it strictly.
(8) Users select
“Lengthening fork” in order to carry widening loads. Pay much
attention not to overload and observe the allowable load and the capacity chart stuck on
the truck. Careful driving should be taken when traveling and turning.
(9) The unloaded forklift truck with attachment should be operated as a loaded truck.
(10) Connect the power and turn on the key switch, select the position of direction
switch, check the truck for normal operation by turning steering wheel, depress the
accelerator pedal softly to keep proper acceleration.
(11) During operation, pay attention to the performance and condition of the system
of machinery, hydraulic, electric etc.
(12) When operate one lever, pay attention not to shift another lever. Don’t operate
the lever at any position out of the driver
’s seat.
(13) The shift distance of control valve lever can control the speed of the lifting or
descending of the goods. When the goods are lifted or descended, the initial speed
shouldn’t be too fast in either case.
(14) When tilting the mast forward or backward to the limit or lifting the fork to the
maximum height, return the directional lever to neutral.
(15) The starting, turning, driving, braking and stopping of the truck should be done
smoothly. When turning on the humid or slippery road, the truck should be decelerated.
(16) Because the forklift truck turns by the rear wheels, the end counterweight may
swing widely when turning. Use care in narrow aisles and other workplaces.
(17) Operate the forklift truck
smoothly, don’t jerk the steering wheel. Avoid sudden
stop, acceleration, stop or turn. In the case of improper operation, the truck will turn over.
In case of this, the driver must keep calm, don’t jump off the truck. The driver must hold