BANTE900P PORTABLE MULTIPARAMETER WATER QUALITY METER
3
INDEX:
No.
CONNECTOR
FUNCTION
1
BNC Connector
For connecting the pH, ORP or Ion Selective Electrodes
2
Phone Jack
For connecting the temperature probe
3
6-pin Connector
For connecting the conductivity electrode or Dissolved Oxygen probe
Inserting the Batteries
Before using the meter, insert three 1.5V “AA” alkaline batteries into battery
compartment, follow the procedure outlined below.
1. Remove the battery
cover from meter’s backside.
2. Insert the batteries into the battery compartment, note polarity.
3. Replace the battery cover into its original position. Installation is completed.
When batteries are depleted, the meter allows you to use the USB cable connected to computer as a temporarily power supply.
Connecting the Sensor
■
Take out the sensors from the packaging.
■
For the pH, ORP or Ion Selective Electrodes:
Insert the BNC connector into corresponding connector socket. Rotate and push the connector clockwise until it locks. After connection
is completed, DO NOT pull on the sensor cord. Always make sure that the connector is clean and dry.
