6.5.1 Output Configuration
Figure 47. Output Configuration screen
Output Functions
• OSSD—to select how many OSSD pairs are used for a given configuration. This component is connected to the
machine control system and associated with the Safety Zone. If an object violates the Safety Zone, the OSSD pair
switches to the OFF state effectively shutting down the machine. The basic model only has one OSSD output pair.
◦
1x2 (one pair)—All OSSD outputs are managed in pairs, two pins. Pins 5 and 6 are automatically assigned to
OSSD 1/1 and 1/2
• Warning—to select how many Warning Zones to use for the configuration. This is the area outside the Safety Zone,
where an object can be detected but the device will not switch the OSSDs to the OFF-State. It can be used to light a
warning lamp or sound a siren. The basic model can have a maximum of two Warning Zones. For each Warning
Zone selected an auxiliary warning output is assigned. If no warning outputs are assigned no Warning Zones will be
created in the configuration.
• Muting—enabling the Muting function allows the scanner to operate under controlled conditions where an object
can pass through the Safety Zone without the scanner's OSSD outputs switching to the OFF-State (see
on page 54). Dedicated devices (mute sensors) must be connected to the scanner input signals to control
this function. The two possible settings are:
◦
Disable—No muting abilities
◦
Enable—Muting turned on, enabling muting limits a configuration to only one Zone Set
• Muting Lamp—if the Muting function is enabled, an optional muting lamp can be connected to a scanner output
signal to indicate when the scanner is functioning in the Muted condition. The scanner display will always display
that the scanner is muted during a muting cycle.
◦
0—No muting lamp output selected.
◦
1—Muting lamp output selected
Output Signals—assigning wires to output signals. Pins 5 and 6 are already assigned as the OSSD pair. Pins 1, 3, and 4 can
be assigned as inputs or outputs depending on the configuration settings. If the pin is assigned as an output, it cannot be
used as an input. From the Output Function screen, pins 1, 3, and 4 can be set as follows (depending on configuration
settings):
• No Function—If the pin is to be used as an input or not at all select no function at this time.
• Warning x—Assign the pin as either auxiliary warning output 1 or 2.
• Muting Lamp 1—Assign the pin as a mute lamp output if muting is selected.
Click on the white > arrow in the upper right corner to move to the next configuration screen. Click on the white < arrow to
return to the previous screen.
SX5 Safety Laser Scanner
www.bannerengineering.com - Tel: +1.763.544.3164
63
