CH 2 Factory Default
Settings:
Setting
Factory Default
Out SEL2
LO
tch SEL2
2-pt tch
OFSt Pct2
10 Pct
Auto thr2
oFF
dLY SEL2
oFF
SEnS SEL2
high
(+)
or
(-)
to set value
(+)
or
(-)
to set value
To scroll through menu lists: Press “+” or “-” To enter a choice list or to select and save: Click SET To exit a choice list without saving: Press and hold SET for 2 seconds
Click SET
to enter choice list
Press and hold SET to exit
choice list without saving
DISPLA
Y
LOOP
Return to Menu List
PROGRAM MODE
Switch Mode
to “PRG”
Click SET
to enter choice list
Click SET
to enter choice list
DIS
PLA
Y
LOOP
Click SET
to enter choice list
Click SET
rocker button
Click SET to select and save a choice in any list
Menu List
on display represents a “w”
If Master (mASt), indicate number of Slaves (1..6) under subsequent “totL SLAV” menu option If Slave (SL
VE), indicate its address (Master address is 0) under subsequent “SLAV Addr” menu option
on display represents a “m”
Click SET
to enter choice list
default setting
setting-specific
Click SET
to enter choice list
DISPLA
Y
LOOP
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
DISP
LA
Y
LOOP
DISPLA
Y
LOOP
DISPLA
Y
LOOP
Available in Lt, dr or wind set only
Not available in CAL Set
Figure 5. CH 2 Program Mode Chart
3.2.1 Output
Selection
Both CH1 and CH2 can be programmed for either light operate (LO) or dark operate (DO). The Channel 2 menu includes
additional
options:
Health (Health Mode Alarm), Comp (Complementary Programming), Set (sets Channel 2 wire as a remote input), Mast (selects
this unit as the master and then allows you to enter the total number of slaves there will be), Slve (selects this unit as a slave and then
allows you to enter this slave address), LED
off,
LED on and Gate.
3.2.2 TEACH
Selection
The DF-G2 can be programmed for one of the following TEACH/SET methods:
• Two-Point TEACH
• Dynamic TEACH
• Window SET
• Light SET
• Dark SET
•
Calibration
SET
Note: A TEACH
Selection
must be selected by programming before TEACH/SET methods can be used.
DF-G2 High Speed Expert Dual Display Fiber
Amplifier
with Dual Discrete Outputs and IO Link
www.bannerengineering.com - Tel: 763.544.3164
9
