Setting up ML Gateway 14
Password
The system password is used for accessing both the web user interface and the command line
interface (CLI). Logging in to the web interface requires entering ‘admin’ for both the user name,
and the password. The factory default password is also ‘
admin
’. Logging into the CLI requires
only entering the password.
The password can be changed here to avoid unwanted access. If the modified password is
forgotten, it can always be reset to the default value. This requires an execution of service
function 2 (described here
link
) .
- Fill in the fields for current and new passwords (twice), and click
Update password
to save the new password.
If the default password is not changed, this notification is displayed on the right side of the
screen. This will disappear when the password is changed.
! It is highly recommended to change it to a unique password.
Master Link Gateway Protocol settings
The ML Gateway protocol is available on RS232 connections and as TCP socket connections (ethernet RJ45). This is a proprietary protocol for
communication with general-purpose home automation controllers. Multiple simultaneous ML Gateway protocol connections are supported.
The options available are:
- Availability and TCP port number on the network connection.
- Authentication required on TCP (Ethernet). Can be ticked if it is required that the connected
Home Automation has to start logging in with Username and Password.
- Availability and bit rate on RS232 port.
The default Master Link Gateway Protocol settings are:
Enable MLGW protocol over ethernet
IP port 9000
Authentication required on TCP (Ethernet)
Enable MLGW protocol over RS232
RS232 bit rate 9600 bps
!
If the RS232 port is already configured for another device, a message is shown and selection is disabled. If RS232 is enabled for MLGW protocol,
the product can not be used with eg. Conson and KNX installation.