Appendix A • Mounting compatibility
Appendix A
Power Panel 500 user's manual V1.40
295
5.2.3 10.4" devices
Cutout tolerance values for the PP100/200, PP300/400, PP500, AP900, PPC700 and PPC800 are ±0,5 mm.
The cutout tolerance values from the AP1000 are +0 mm/-0.5 mm.
323 x 260
10
10
8.5
8.5
Outer contour of device
Cutout for device
303 x 243
PP100/200/300/400
AP900/PPC700
PP100/200/300/400
AP1000
PP500
PP500
AP1000
AP900
Figure 172: Mounting compatibility - 10.4" device - Horizontal1
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700, Power Panel 500 devices and Power Panel
100/200/300/400 devices are 100% mounting compatible in Horizontal1 format.
Outer contour of device
Cutout for PP100/200/300/400 device
PP100/200/300/400
AP900/PPC700
13 PP100/200/300/400
8.5 AP900, PPC700, PP500, AP1000
Cutout for AP900/PPC700 device
4.5
423 x 288
10
10
8.5
402 x 271
402 x 266.5
403 x 271
PP500
Cutout for PP500/AP1000 device
AP1000
Figure 173: Mounting compatibility - 10.4" device - Horizontal2
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700 and Power Panel 500 devices are not 100%
mounting compatible with Power Panel 100/200/300/400 devices in Horizontal2 format. Automation Panel 1000,
Automation Panel 900, Panel PC 700 and Power Panel 500 devices require a cutout that is 4.5 mm higher (bottom
edge).
The larger cutout can be used for all devices under certain conditions:
•
When mounting, make sure that the PP100/200/300/400 devices are placed and mounted as close to the
center of the cutout as possible. Failure to do so can prevent the retaining clips from holding firmly, which
means that a firm seal is no longer guaranteed with the gasket (IP65).