Installation • Installation
130
Power Panel 500 user's manual V1.40
1.2.1 Procedure
1. Insert the device into the front side of the smooth, flat installation cutout. The number and design of the
clamping blocks may vary depending on the size of the device. The required dimensions of the installation
cutout can be found in section 3 "Individual components".
Figure 55: Device with clamping block inserted in cutout
2. Fasten the clamping blocks to the wall or control cabinet by tightening the screws with a hex key (M4).
Tightening the screw presses down the integrated clamping lever to hold the device securely in place. The
fastening torque should be approximately 0.5 Nm.
Figure 56: Fastening the clamping blocks