Bandini Industrie Gi.Bi.Di. BA24, Инструкции по установке

Страница: 39 / 198

BA24
39
UK
FINAL OPENING AND
CLOSING STROKE
C8
N
Disables the final closing stroke in opening and closing
Y
Enables the final opening and closing stroke.
Operation:
At the end of the working time during opening and closing without
deceleration, a 2 s pulse is given with the power set in menus F1 and F5.
When deceleration is active, the pulse is given at the end of the
deceleration time.
The final stroke is regulated by the amperometric level in menus F3 and
F7.The final stroke is not controlled by the safety devices (edge/anti-
crushing).
Not active with the sliding configuration.
COSTA
C9
NC
8K2
Enables the edge provided with 8K2 in series resistance
ANTI-CRUSHING /
LIMIT SWITCH AMPEROMETRIC
C10
Anti-crushing not enabled / limit switch amperometric
Y1
ABILITATO AMPEROMETRICA DI FINE CORSA (The amperometric
inverts the motion).
NOTE: ENABLE THE ANTI-CRUSHING ONLY IF ALSO THE LIMIT
SWITCHES ARE ENABLED.
Y2
ENABLED LIMIT SWITCH AMPEROMETRIC (The amperometric stops
the motion)
N
COURTESY LIGHT
WITH TWO MOTORS
C11
Y
Active the courtesy light 24V max 10W in presence of 2 motors.
Operation:
Active on the electrical lock output 2 for 3 minutes after the end of the
motors movement.
Courtesy light not activated with 2 motors. N
T3 ADDITIONAL TIME
C13
N T3 excluded.
YF
T3 = time set for deceleration (H3 – H6) with the same menu F1 and
F5 settings
YS
T3 = time set for deceleration (H3 – H6) with the same menus F2 and
F6 settings
INVERSION FROM PEDESTRIAN
C14
Y
During the PEDESTRIAN closing, the PHOTO 1 – PHOTO 2 –
PEDESTRIAN command opens only the pedestrian.
The START command causes the complete opening.
N
During the PEDESTRIAN closing, the PHOTO 1 – PHOTO 2 –
PEDESTRIAN – START command causes the complete opening.
Enables the edge provided with the N.C. contact (normally closed)
FLASHING LIGHT
C15
Y
Blinking flashing light output.
N
Fixed flashing light output.