Bandini Industrie Gi.Bi.Di. BA24, Инструкции по установке

Страница: 38 / 198

BA24
38
UK
Enables 3-second pre-flashing before motor start
PRE-FLASHING
C3
Y
N
Disables pre-flashing.
The flashlight and the motors start at the same time.
Enables the safety devices test. See also menu C20.
When the device is activated (edge intercepted), the writing SAF
appears on the LCD
Operation:
PHASE 1: when the Start or the Pedestrian command is given, the
amperometric circuit is tested. If an anomaly is detected, it will be
indicated by 4 long flashing (2 sec.) of the flashing light.
PHASE 2 : If the edge with N.C. contact is enabled, when the Start or
Pedestrian command is given, the power to the safety devices is cut off
for 0,5 seconds and then restored: if the inputs of the safety devices
open and immediately return N.C., the motors start, otherwise a fault is
signalled with 3 long flashes (2 sec.).
PHASE 3 : if the edge 8K2 is enabled, when the Start or the Pedestrian
command is given, the COSTA. Input is tested (value 8K2). If the value
is not correct, the fault is signalled with 2 long flashes (2 sec.).
WARNING: The indication of the fault detected will be only one (the first
one to be detected) even if there is more than one fault.
SAFETY DEVICES TEST
C4
Y
N
Disables the safety devices test.
Enables the single limit switch reading.
See the paragraph “LIMIT SWITCHES USE”
LIMIT SWITCH
C5
E1
N
Disables the limit switch reading.
E2
Enables the double limit switch reading.
See the paragraph “LIMIT SWITCHES USE”
DECELERATION
C6
N
Disables the deceleration function
Y
Enables the deceleration function
HAMMER STROKE
C7
N
Disables the hammer stroke function
Y1
Y2
Enables the hammer stroke function in opening to allow the
unhooking of the electrical lock.
Enables the hammer stroke function both in opening and in closing to
allow the unhooking of the electrical lock.