Bakers Pride FC-516, Руководство по эксплуатации

Страница: 7 / 18

IL FORNO CLASSICO OVEN OPERATION MANUAL
5
INSTALLATION INSTRUCTIONS
A. Three Deck Installation:
(a) Slide one slab into the bake chamber and push
it as far as possible to one side.
(b) Slide the second slab into the bake chamber
on the side opposite to the first slab.
(c) Slide the third slab into the center section.
(d) Use metal shims as needed to level the slabs.
(e) Use two wedges in the back and another on
one side of the decks. The three slabs should
be tight against each other with no gap in
between them (See Sketch “H”).
B. Four Deck Installation:
(b) Slide the second slab into the bake chamber
and push it next to the first slab in the rear.
(c) Slide the third and fourth slabs in front of the
slabs already in place.
(d) Use metal shims as needed to level the slabs.
(e) Use one (FC-516) or two (FC-816) wedges in the
back and another on one side of the decks. The
four slabs should be tight against each other with
no gap in between them (See Sketch “I”).
C. Optional Ceramic Top Installation
(Refer to Top Brick Lining Illustration, Page 6):
If the oven was ordered with the ceramic top
option, the two top supports are already installed.
Simply slide in the ceramic tops as per instructions
Sketch H
below. If this option is an add-on, you must follow
the instructions provided with the Ceramic Top
Installation kit.
a) Through the arched front opening, insert one
of the center slabs (20 13/16 x 20 13/16 for
FC616 and FC816)(17 1/2 x 17 3/4 (left to
right) for the FC516) into the bake chamber,
raise one side until the other side comes to
rest onto the center support, then lower the
first side to lock it in between the two center
supports. Push it to the rear as far as possible
to make room for the second center slab.
b) Install the second center slab (20 13/16 x 20
13/16 for FC816)(14 3/16 x 20 13/16 (left
to right) for FC616)(17 1/2 x 17 3/4 (left to
right) for FC516) into the bake chamber and
push it tightly against the first slab.
c) Install the side slabs (20 13/16 x 20 13/16
for FC816)(17 1/2 x 17 3/4 (left to right)
for FC616)(17 1/2 x 13 3/4 (left to right) for
FC516) in a similar fashion, raising the slab
in the center until the lower side edge rests on
the side support, then lowering the upper edge
onto the center support. First the ones in the
rear, then the ones in the front, pushing them
tightly against the first slabs.
Sketch I