Baja WD250U, Руководство по обслуживанию

Страница: 183 / 232

4) Inspection
• Reverse fork (1)
If wear/abrasion/bend/damage is found on the
surface connecting with connecting jaw and
reverse operating shaft, replace it.
• Compressing spring (2)
If the elasticity is lost, or worn, replace it
• Steel ball (3)
If wear, damage, or scratch marks are found,
replace it.
5) Inspection:
• Reverse fork shaft
Roll the reverse fork shaft on the flat surface, if
bent, replace it.
CAUTION:
Never straighten a bent shaft and reuse it
6) Inspection
• Flexibility of fork movement
Install the reverse fork 1 to fork shaft, if not
active or smooth in operation, replace fork and
fork shaft.
7) Inspection
• Reverse control lever (1)
• Operating plate (2)
• Reverse operating shaft (3)
If bends, cracks, or damage is found, replace it.
8) Inspection
• Rear cover (1)
If cracks or damage on the position connecting
with left crankcase, rear driving cover is found,
replace the rear cover.
• O-ring (2)
If damaged or deformed, replace it
CAUTION:
When replacing the rear cover, be sure to read -
just the gear core washer, refer to “Selection of
adjusting washer” section.
182