Baja WD250U, Руководство по обслуживанию

Страница: 50 / 232

(IX) Adjustment of toe-in on front wheels.
1. Rest the vehicle on level ground.
2. Measurement:
• Toe-in, adjust if not in specification.
Adjustment steps for toe-in
• Mark the center of tire thread on both front
wheels
• Lift the front end to keep force off wheels
• Point tires forward, measure the width between
the marks made on tire (A) .
• Rotate the front tires 180˚ in reverse.
• Measure the width B between two marks.
• Calculate the toe-in with the following formula
Toe-in= (B) - (A)
Standard value of toe-in:0.5mm
• If the toe-in is not correct, adjust
3. Adjustment
Adjustment steps of toe-in:
• Mark determination marks at the end of t left/
right tension rod (1)
• Loosen the locking nuts at the end of left/right
tension rod (2)
• Left/right tension rods (3) should turn the same
turns left or right up to obtain the specified toe-in
and make the lrft/right tension rods are the same in
strength.
Tighten up the locking nuts (2) at the end of left/
right tension rod.
Torque of locking nut: 30N·m
CAUTION:
• Make sure that the left/right tension rods have
been adjusted the same. Otherwise the vehicle will
still go forward left and right.
• After adjusting the toe-in correctly drive the
vehicle to test the toe-in adjustment. If the steering
is not normal as specified, adjust again.
1
2 3
50