Baja WD250U, Руководство по обслуживанию

Страница: 73 / 232

(I) Trouble
• Trouble judging guidance
Performance Possible Reason
1. The vehicle appears to stop or there is irregular A. Damaged bearing
axial run-out with an abnormal noise while the B. Improper clearance
vehicle accelerates, decelerates, or is in idle state. C. Damaged gear
(Make sure not to confuse with engine trouble) D. Driving shaft breaks
2. The vehicle makes an obvious boom sound at E. Gear teeth break
low speed and “Wu Wu” sound when decelerating F. Jam caused by
or accelerating. There is also a regular snap from shortage of lubricating
the case body. oil
3. The rear wheel can not rotate and the G. The gear is jammed
transmission shaft jams by foreign matter
CAUTION:
“A”, “B”, and “C” are difficult to judge because the performance is very subtle and it’s difficult
to distinguish them from normal operating noise. Remove these parts for special inspection if
you think they may have been damaged.
(II) Inspection
1. Check abnormal noise:
The following noises may indicate mechanism trouble
a. Boom when vehicle is sliding, accelerating, or decelerating. The noise is not direct ratio with
higher engine and transmission case speed, but is direct ratio with rear wheel speed.
b. “Wu Wu” noise is different when accelerating or decelerating.
Cause: Incorrect assembly or teeth clearance is too small.
CAUTION:
Noise must differentiate from normal operating noise of vehicle.
Judgment: Teeth of gear cracked
WARNING:
You should stop driving immediately if there is any doubt that the gear teeth cracked. This could
mean that the transmitting components are jammed by gear fragment and it is possible to lose
control of the vehicle, possibly injuring the driver.
2. Check following condition:
a. Drain the lubricating oil
72