Bailey C-I-CV42C, Инструкция

Страница: 46 / 214

WBPEEUI220771A0 6 - 1
Section 6
Repair and Replacement
Introduction
This section provides repair and replacement procedures for
the Conductor VMS Series 42 Auxiliary Terminal.
NOTE: Follow the procedures for working with static sensitive devices when
performing the repair and replacement procedures.
Repair and Replacement Sequence
Refer to Figure 6-1 for the repair and replacement sequence for
the auxiliary terminal. Figure 6-1 points to either Figure 6-2 ,
6-3 , 6-4 , 6-5 or 6-6 depending on the area of the workstation
the component to be repaired or replaced resides.
Each block of the flow represents a single task that must be
completed before continuing with the sequence. In some cases,
more than one path can be taken during repair and replace-
ment procedures. For paths that are in parallel, either com-
plete all of the tasks in all of the paths before continuing or
complete all of the tasks in only those paths that apply before
continuing. At least one path must be completed.
Some blocks contain alphanumeric codes. These codes identify
the procedure that describes the steps to complete an indi-
cated task. Complete all of the steps given in a procedure
before continuing to the next procedure. By treating each task
as a separate entity, the procedures provide an easy method
for finding the information needed for each task in the repair
and replacement sequence.
The procedures have check boxes in the margin by each proce-
dural step. When performing a procedure, check each box as
each step is completed.