Baileigh WR-84V-ATC, Руководство оператора

Страница: 35 / 56

33
33
5.
Scroll to and load the file “T1.NC”. This will be the file number for tool number 1 in which you
are going to measure.
6. When the file is loaded, press the (Start) key to execute the program to change to the
desired tool.
7. Once tool number 1 is loaded and the program is completed, press the combination keys of
+ (Shift + X+) to enter the tool measurement operation. When asked, press the
(OK) key. The spindle will move to the position over the tool touch sensor and lower
and touch the sensor. While lowering, the speed will change from a fast speed to a slow
speed. This is both normal and required. If the spindle is lowering at the fast speed when the
bit contacts the touch sensor, it will crash the touch sensor. This would indicate that the bit
that is installed is too long for this system. The bit should not extend out of the collet more
than 2
” (50mm).
8. The bit will touch the sensor, (typically twice and may appear as a quick bounce), and then
lift approximately 1mm above the touch pad.
9. When completed, tool number 1 has been measured and that Z coordinate will have been
recorded within the systems memory.
10. Repeat these steps for each tool holder and bit assembly.
11. Once completed, this will need to be repeated when the bit in the holder is changed in any
way, either by sharpening, or replacing or similar change.
Manually Changing Tool Holders
IMPORTANT: If the Tool No. in the program does not match the tool location in the
tool magazine, the result will be a damaged project and possibly damage to the tool and table.
DAMAGE DUE TO INCORRECT TOOL NUMBER SETTING AND TOOL PLACEMENT IN THE
TOOL MAGAZINE WILL NOT BE COVERED UNDER WARRANTY.
When needed, the tooling may be changed manually.
1. Install the desired bit into the tool holder.
2. Make note of and if needed, mark the tool holder so that it is loaded into the correct
magazine location. Remember, the tool magazine location MUST match the tool number for
the program to be used to machine the material.